Specifications

Synergy Nano Technical Manual, Revision -
Page 285
17.4.2 12-Channel Triac Board Mounting
Triac output boards are used with the Synergy Nano Plus to switch power to the AC loads of the chamber
machinery. The 12-Channel triac board (P/N TE1151-12) should be mounted to a panel inside the
electronics enclosure. The figure below identifies the mounting hole locations for the 12-Channel board in
blue .
Provisions for stacking two 6-Channel Triac boards (P/N TE1151-6) on the 12-Channel unit are provided.
These two boards are the 2SM and 3SM boards from the 6.10 chamber configuration list. The eight holes in
the figure below for this purpose are indicated in red .