Specifications

Synergy Nano Technical Manual, Revision -
Page 287
TE1151-6 Triac output board
The Triac output board can drive 6 small AC loads. It can also drive a Solid State Relay (SSR) module.
When driving an SSR, an additional load resistor is required across the SSR input to prevent nuisance firing
as a result of leakage current. And finally, the Triac output can drive an external high current Triac as
shown below.
17.4.5 Retransmit Outputs
Wire retransmit outputs to the chart recorder or control valves as necessary. Use 4-20 mA converters as
required. See Section 6.4 Special Functions
for setup details. The following table displays the connector
and pin numbers for the Synergy Nano’s two analog retransmit outputs. Below the table is an image of the
Olympic Board connector P4, pins 9-12.
Analog Retransmit Connections Table
Signal Connector & Pin Number
Analog Retransmit 1 P4-Pin 11
Return P4-Pin 12
Analog Retransmit 2 P4-Pin 9
Return P4-Pin 10