Specifications

Synergy Nano Technical Manual, Revision -

Page 288

17.6.1 Synergy Nano Plus: GPIB, RS-232 and RS-485 Communications Wiring

The Synergy Nano Plus supports GPIB/IEEE 488, RS-232 and RS-485 communications through the Olympic

board. The figure below shows the connectors and cable wiring for these. For information on the

communications protocol supported by these ports see Synergy Nano Communications Section 18

of this

manual. In addition, see the Communications screen for communications parameters. Note that the RS-485

port can be used as a slave communications port for computer control as well as a master port for UUT

sensor monitoring. See the UUT Section 13.0

of the manual for information on UUT module setup.

TE1608, Dual Communications Cable

RS-232 /RS-485

TE1596, GPIB/IEEE 488 Communications Cable

RS-232 (DB9 Female)

User Communications

TE1596

Communications

Cable for

GPIB/IEEE 488

TE1608 Dual

Serial Cable

RS-485 (DB9 Male) for

UUT Thermocou