Specifications

Synergy Nano Technical Manual, Revision -
Page 337
Example 2
This example demonstrates the Synergy Nano
temperature setpoint command.
To setup this example we connected to the
chamber as we did in Example 1, then
performed the following steps.
1. Type “= SP1 23.7” in the Command
field. Note the space between “=” and
“SP1” and between “SP1” and “23.7”
and don’t type the quotes.
2. Press the Send button and note the OK
in Response field. The controller
responds with OK when the command
is accepted.
Example 3
This example demonstrates the controller’s
setpoint query command and multi-command
capability .
To setup this example we connected to the
chamber as we did in Example 1, then
performed the following steps.
1. Type “? SP1;= SP1 55.3;? SP1;? C1” in
the Command field. Note the spaces
between parameters and the
semicolons between commands.
2. Press the Send button and note the
Response field.
The controller replies with the response from
each command separated by a semicolon. i.e.
the first response is the temperature setpoint.