Specifications

Synergy Nano Technical Manual, Revision -
Page 73
Vent – Boost Cool
This output specifies to use either Vent or Boost Cool.
Output is On/Off
OT18 Selects the Control logic for the Vent – Boost Cool device
L14 Time Delay Boost Cool Time delay (in seconds) required before Boost Cool is
enabled
Turn On Timer is reset when Channel 1 PID Cool < 100%
PID Humidify
This output energizes the humidity generator and controls water vapor injection into the chamber.
Output is Time Proportioning
Affected By: Default Value: Range:
Channel 2 Proportional Band Heating 42 0 - 50 Degrees C
Reset for Channel 2 Heating 0.02 0 - 9.9 Repeats/minute
Rate for Channel 2 Heating 0 0 - 9.9 Minutes
Cycle Time for Channel 2 Heating 1 1 - 60 Seconds
Rate Band for Channel 2 Heating 0 0 - 7 Seconds