Specifications

Synergy Nano Technical Manual, Revision -
Page 8
Controller Configurations
There are four Synergy Nano configurat6ions. With them and the previous four other configurations there
are a total of eight Synergy Controller configurations. This technical manual covers the Synergy Nano
Configurations. The Synergy V, Synergy Compact, Synergy Micro and Synergy Micro V are covered in the
Synergy Controller technical manual however; images of these other configurations are shown in the table
on the page after next for reference.
The Synergy Nano N1, N2, N3 are virtually identical, the only difference between them is in the output
configuration (transistor, SSR, relay) of their six main outputs. The fourth configuration, Nano Plus is
significantly different than the other three in that it utilizes the Synergy Olympic board for input and output
and thus can support more chamber functions than the three stand-alone models. More significantly,
however, is that the Nano Plus can easily retrofit into VersaTenn applications since it supports the same
output wiring scheme. The unique features of each Nano configuration are listed in the table below along
with an icon for each. Features that aren’t supported by all four configurations are identified in this document
with the icons in the margins that indicate configurations supported.
Type
Synergy Nano 1 Synergy Nano 2 Synergy Nano 3 Synergy Nano +
Icon
P/Ns
TE1858-1 TE1858-2 TE1858-3 TE1858-4
Processor
ARM ARM ARM ARM
Main Outputs
(6) Transistors
Open Collector
(6) SSRs
Solid State Relays
(6) Relays
Mechanical Relays
Expanded
Olympic Board
Ethernet
10/100 BaseT 10/100 BaseT 10/100 BaseT 10/100 BaseT
OS
5.0 5.0 5.0 5.0
The following table shows each of the above mentioned configurations with its corresponding image.
Synergy Nano Front
Synergy Nano Rear