Technical information

3/34
1SDC210033D0202
Accessories
Accessories for electronic trip units
Accessories for electronic trip units
Ekip Display Ekip LED Meter SACE PR212/CI External neutral
Distribution protection
Ekip LS/I – – – –
Ekip I – – – –
Ekip LSI
QQ
–
Q
Ekip LSIG
QQ
–
Q
Motor protection
Ekip M-I – – – –
Ekip M-LIU – – – –
Ekip M-LRIU
QQQ
–
Generator Protection
Ekip G-LS/I – – – –
Oversized Neutral Protection
Ekip N-LS/I – – – –
Energy measurement
Ekip E-LSIG
QQ
–
Q
Ekip Display
The Ekip Display is a unit which can be applied on the front of the solid-state trip unit and shows the
current values, alarms and protection and communication parameter programming.
Main features:
Q
installation: Ekip Display can easily be installed on the front of the Ekip LSI, Ekip LSIG, Ekip
M-LRIU and Ekip E-LSIG electronic trip units. It is connected by means of the test connector on
the front of the trip unit, and fi xing is simple and reliable thanks to a specially designed mechanism.
This mechanism also provides a practical way of fastening the accessories to the circuit-breaker
in order to prevent undesired access to the dip-switches. Installation can be carried out under
any conditions, even with the door closed and the electronic trip unit already on and functioning;
Q
functions: Ekip Display has four buttons for browsing through the menus. It functions in the
self-supply mode starting from a current of I>0.2xIn circulating through at least one phase.
Backlighting is activated in the presence of higher loads, thereby allowing a better leggibility of
visualized informations. The rear lighting comes on in self-supply for a current I>0.4xIn and is
always on when there is electronic trip unit auxiliary power supply.
Ekip Display:
– shows the current values;
– shows the settings of the protection functions in Amperes or in In;
– shows the protection that caused the release to trip and the fault current (only when there is
24V external voltage or the Ekip TT unit);
– allows the trip thresholds of the trip unit to be programmed and the communication param-
eters to be set on bus system;
Q
compatibility: Ekip Display can be fi tted even when front accessories, such as the motor, direct
and transmitted rotary handles etc. are already installed. It's possible to use Ekip TT or Ekip T&P
without removing Ekip Display. It's not possible to use Ekip Display when the breaker is in the
withdrawable version.
Display Push-botton
Power-on LED
Display
Fixing Device
Ekip TT or Ekip T&P
connector
Slot for lead seal