Technical information

3/35

1SDC210033D0202

Ekip LED Meter

The Ekip LED Meter can be applied to the front of the electronic trip unit and displays the current

values and alarms.

Main features:

installation: Ekip LED Meter can be easily installed on the front of Ekip LSI, Ekip LSIG, Ekip

M-LRIU and Ekip E-LSIG electronic trip units. It is connected by means of the test connec-

tor on the front of the release and ﬁ xing is simple and reliable thanks to a specially designed

mechanism. This mechanism also provides a practical way of fastening the accessories to the

circuit-breaker in order to prevent undesired access to the dip-switches. Installation can be car-

ried out under any conditions, even with the door closed and the electronic trip unit already on

and functioning;

functions: Ekip LED Meter provides an accurate indication about the value of the current cir-

culating in the trip unit. It does this by means of a scale of LED. Their different colours allow the

normal operation, prealarm and alarm states of the circuit-breaker to be recognized at a glance.

It functions in self-supply mode from a current of I>0.2xIn circulating through at least one phase

or when electronic trip unit’s auxiliary power is available;

compatibility: the Ekip LED Meter can also be ﬁ tted when front accessories, such as the motor,

direct and transmitted rotary handles. It's possible to use Ekip TT or Ekip T&P without removing

Ekip LED Meter. It's not possible to use Ekip LED Meter when the breaker is in the withdrawable

version.

SACE PR212/CI contactor operator

PR212/CI is an interface device that allow Ekip M-LRIU to comand the contactor. The stand-by

position normally corresponds to the opening position of the main contacts. PR212/CI can be used

in conjunction with XT2-XT4 circuit-breakers equipped with the electronic trip unit for Ekip M-LRIU

motor protection.

Main features:

installation: PR212/CI can be installed both on a DIN rail and on the back of the door. It is con-

nected to the electronic trip unit with a dedicated connector, which has to be ordered in relation

to the circuit-breaker version;

functions: when the release is set to “Normal Mode” the contactor can be opened if a fault oc-

curs due to overload L, locked rotor R or phase failure/unbalance U.

Power-on LED

LED signalling the % of

current for each phase

Timing LED

Fixing Device

L, S, I, G protection LED

Ekip TT or Ekip

T&P connector

Slot for lead seal