Technical information

3/37

1SDC210033D0202

HMI030 interface on the front of the switchboard

HMI030 is an interface on the front of the switchboard only usable with protection trip units ﬁ tted

with Ekip Com.

Accessories

Communication devices and systems

Main features:

installation: HMI030 can be ﬁ tted into the hole in the door using the automatic click-in method.

In situations where mechanical stress is particularly intense, it can also be installed by using the

special clips supplied. It must be connected directly to the Ekip LSI, Ekip LSIG, Ekip M-LRIU

or Ekip E-LSIG protection trip unit with Ekip Com via the serial communication line. HMI030

requires a 24V DC power supply;

functions: HMI030 consists of a graphic display and 4 buttons for browsing through the men-

us. This accessory allows you to view:

– the measurements taken by the release to which it is connected;

– the alarms/events of the release.

Thanks to its high level of accuracy, the same as that of the trip unit protection, the device is a

valid substitute for conventional instruments without any additional current transformers.

communication: HMI030 is provided with two communication lines, to be used in alternative:

– Modbus

– Local Bus.

Connecting Ekip LSI, Ekip LSIG, Ekip M-LRIU or Ekip E-LSIG to the Local Bus gives the possibil-

ity to connect the Modbus line of the Ekip Com module to a different communication network.

Consult the Electrical Diagrams Chapter for further details about wiring.

Alarm LED

Display

Display push-botton

LED signaling the % of current for each phase