Owner's Manual

15
▪ IR Setting 1 and IR Setting 2
This page requires that the IR commands are available in plain text files
using the CCF IR code format.
1. Select the desired IR Control Setting tab.
2. Click the Load button to load the respective IR command. If the display
device only support a power toggle IR command, then use the same file
for both the Power On and Power Off modes.
3. Use the Test button to confirm that the command functions.
4. Click the Save button to save both IR commands to the Matrix.
8. ASCII control command
The Matrix also supports ASCII control. You need to a RS-232 phoenix connector male
head to RS-232 female head with DB9 serial cable and a RS-232
male head with DB9 to USB male head serial cable. The phoenix connector
male head is connected the RS-232 port of the Matrix, and the USB head of
the serial cable is connected a PC. Open any of a Serial Command tool on
PC such as “Docklight” to send command to control the Matrix. Please see the
following connection diagram;