SimpliPhi Power PHI Battery INTEGRATION GUIDE: MIDNITE SOLAR Optimized Energy Storage & Management for Residential & Commercial Applications Utilizing Efficient, Safe, Non-Toxic, Energy Dense Lithium Ferrous Phosphate (LFP) Chemistry © SIMPLIPHI POWER, INC.
SimpliPhi Your Energy Security and Independence and gain control of your own power. SimpliPhi helps you manage your power as a personal resource. Anytime, anywhere, SimpliPhi energy storage systems optimize integration of any power generation source – solar, wind, generator – on or off grid and protects your home and mission-critical business functions from power outages and intermittency.
Table of Contents 1.0 – Introduction ........................................................................................................................................................................................................4 2.0 – Charge Controller Settings ........................................................................................................................................................................4 3.0 – Battery Bank Sizing ............................................
1.0 – Introduction This Integration Guide is intended to supplement the PHI Battery and Midnite Solar Installation Manuals. It covers the recommended set up and configuration of Midnite Solar Charge Controller equipment for optimizing performance with SimpliPhi PHI batteries. More information on SimpliPhi products can be found on our website: https://simpliphipower.com/. Specifically, the Product Documentation section of SimpliPhi’s web site (https://simpliphipower.
Note: Refer to the Discharge Calculation instructions included in your relevant inverter manufacturer Integration Guide. When comparing the same system using these two calculations for sizing the PHI battery bank, the minimum number of batteries should be the greater of the two results (Discharge Calculation & Charge Calculation). 3.2 – Midnite Solar Charge Controller Battery Bank Sizing Examples The Midnite Solar charge controller’s charge current ratings vary by model.
4.2 – Charge Controller Settings Please review Table 2.0 below for Midnite Solar charge controller program settings. To initiate a factory reset, hold left & right arrow buttons while turning on Battery Breaker. This is normally only done for initial setup, as doing so will erase all custom settings. Table 2.0 - Settings for SimpliPhi PHI 3.
5.0 – Specifications & Warranty For your reference: • • • See PHI 3.8 kWh 48V Specifications sheet. See PHI 3.8 kWh 48V 10-Year Warranty. Failure to adhere to installation protocol will void Warranty. 6.0 – SimpliPhi Technical Support For technical support related to your PHI 3.8 kWh or PHI 2.9 kWh Battery (or other SimpliPhi Power products), please contact us directly at: 805.640.6700 techsupport@simpliphipower.com SimpliPhi Power, Inc.
