AccESS Installation Manual

Table Of Contents

REV020620

| 30 |

If purchased with the Conext Gateway or ComBox option, please refer to the Conext Gateway or

ComBox Owner’s Guide from Schneider Electric.

Network Requirements

Before making AC and DC connections, route communication cables through the raceways. For

easier identification, use a different color for each communications cable, or cable tags.

Connect communications cables to their components after AC and DC connections are made.

4.6.3 – Automatic Generator Start

Schneider Electric Conext AGS

If purchased with the Conext Automatic Generator Start, please refer to the Conext Automatic

Generator Start Owner’s Guide from Schneider Electric.

4.6.4 – Battery Monitoring

Schneider Electric Conext Battery Monitor

If purchased with the Conext ComBox, the Conext Battery Monitor is included on the exterior

door. This comes pre-wired and configured, but for more information, see the Conext Battery

Monitor Quick Start Guide.

5.0 – Programming

5.1 – Depth of Discharge

The AccESS comes pre-programmed for 80% depth of discharge (DoD), assuming the AccESS is connected

to an AC power source such as the grid or a generator. This qualifies for the 10-year / 10,000 cycle

Warranty on the PHI 3.8 Batteries.

To change the DoD to the 5,000 cycle Warranty or 3,500 cycle Warranty, modify the voltages in the Basic

Settings and Advanced Settings per the Programming section. Refer to the PHI 3.8 Battery Warranty.

If a firmware update is executed on the AccESS, please verify all PHI custom settings are still in place.

These settings can be found at the end of this manual in Section 7.0: Operating Parameters.

5.2 – Configuring the Schneider Electric Conext XW+

The Schneider Electric Conext XW Pro or XW+ is capable of many different modes of operation via

configurable settings. This includes:

• AC Input Settings

• Grid Support Settings

• Prioritizing and Managing Energy Sources

• Generator Support Settings

• Auxiliary Output Settings

− These settings can be modified to support the function the owner would like to achieve with the

AccESS unit. To configure the AccESS, please refer to Schneider Electric’s Conext XW Pro or XW+

Inverter/Charger Owner’s Guide.

−