AccESS Installation Manual

REV020620
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail]| SimpliPhiPower.com
| 36 |
5.3.3 – Battery Monitor
Table 5.0 – Programming Settings for SimpliPhi PHI 3.8 kWh 48V Battery w/Schneider Electric Conext Battery Monitor
Conext
Battery Monitor
10K Cycles Warranty
5K Cycles Warranty
3.5K Cycles Warranty
Advanced Settings
80% DoD
90% DoD
100% DoD
Capacity
2
75Ah per PHI 3.8
Discharge Rate
20 Hrs
Nominal Temp
67F
Shunt Amps
500
Shunt mV
50
Self Disch
<1%/Month
Discharge Floor
20%
Float Voltage
53.32
Float Amps
2%
Auto Sync Time
240 Sec
Temp Unit
Celsius
Back Light Timer
30 Sec
Peukert Expo
1.05
Charge Eff Mode
Automatic
Temp Coeff
0.5Ah/degC
Default Temp
76 Deg F
Sync Sensitivity
5
Time Rem Filter
Faster
Notes:
1. Maximum setting of 48V limited by some inverter firmware is below the recommended setting.
2. Per PHI 3.8 Battery – These setting are calculated by multiplying the nominal per battery value times the # of
batteries.
3. Levels are typical @ 25C and may need adjusting at temperature extremes.
4. When performing rapid deep charge/discharge cycles the battery should be allowed to "rest" 15 minutes in
between.
Auto Generator Start (AGS)
Table 6.0 – Programming Settings for SimpliPhi PHI 3.8 kWh 48V Battery w/Schneider Auto Generator Start
AGS
10K Cycles Warranty
5K Cycles Warranty
3.5K Cycles Warranty
Advanced Settings > CFG Trigger
80% DoD
90% DoD
100% DoD
Start DCV 30 sec
50.5V
49.8V
48V
Load
Enabled for the AccESS 1.0
Disabled (unnecessary) for 4 or more PHI 3.8’s
Strt Load
20A for the AccESS 1.0
Stop Load
18A for the AccESS 1.0