AccESS Installation Manual

REV020620
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com| SimpliPhiPower.com
| 7 |
1.2.3 Battery Management System (BMS)
The PHI 3.8 Batteries within the AccESS unit are manufactured utilizing Lithium Ferrous
Phosphate (LFP) cells, which are produced under exclusive patented licensed technologies, as well
as proprietary materials, architecture, manufacturing processes and battery management system
(BMS). This assures the highest grade and quality, longest cycle-life, greatest efficiency and
freedom from material impurities, toxicity and hazardous risk.
Each PHI 3.8 Battery within the AccESS unit contains circuitry that protects the Lithium Ferrous
Phosphate cells from overcharge, over-discharge and excessive load amperage. If the values
specified are exceeded, the protective circuitry will shut down the flow of electricity to/from the
PHI 3.8 Batteries. In some cases, this will result in the need to re-initialize an inverter charger.
Often, inverter system settings will be saved within the inverter memory storage and will not need
to be reset. This is not an absolute standard but is common amongst most inverter chargers and
should be anticipated if the PHI 3.8 Batteries go into a state of self-protection and shut down the
flow of electricity.
1.2.4 PHI 3.8 Battery Connection Terminals
The PHI 3.8 Batteries are equipped with two 3/8’’ threaded studs with a lock washer and nut. The
red colored high temperature molded insert connection is for the positive lead. The black colored
high temperature insert connection is for the negative lead.
CAUTION: Do not attempt to loosen the large brass nut at the base of the terminals. This
will Void the Warranty.
CAUTION: Do not reverse polarity. It will Void the Warranty. Use a voltmeter to check
polarity before connecting terminals.
Water Resistant Cable Boots are also included and will be in place when your units arrive. The
boots are to be placed over the cable terminations and will stretch to form a water-resistant seal
around the base of the molded inserts and terminal connections.