User's Manual

visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
4
1. Install your system
Remove the battery activation strip.Þ
Plug the Base Station into a power outlet using the Þ
included power cord.
Tip: Locate the Base Station in the same room as your
main entrance to make it easier to hear voice prompts
while using the system.
OptionalÞ : If you have a landline and plan to subscribe to
the Emergency Dispatch Service, you may plug the Base
Station into a telephone jack to provide an alternative to
your wireless connection to the Dispatch Service.
Tip: If you have a DSL Internet connection, you will need
to place a filter on this line, just like any other phone.
A. Plug in the Base Station
(optional)
Remove the battery activation strip. Þ
Adhere the Keypad to the wall by your main entrance.Þ
Tip: Adhesive tape has already been installed on the back
of the Keypad – just peel and stick. If you make a mistake,
see “How do I move a sensor?” on page 10.
B. Install the Keypad by your door
Remove the battery activation strip.Þ
Adhere the Panic Button to a wall. Þ
C. Install the Panic Button
Remove the battery activation strip.Þ
Place the Motion Sensor on a shelf or adhere it to a wall, Þ
approximately 4 to 5 feet off the ground.
Avoid placing the Sensor near a heater, air conditioner,
or in direct sunlight. If you have pets, put the Sensor at
least 5 feet off the ground, out of their reach. The Motion
Sensor will not detect most small pets, if the pet cannot get
within 5 feet of it. If you have larger pets, please contact
SimpliSafe for assistance.
D. Install the Motion Sensor