User's Manual

visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
18
We recommend you test your system regularly and after making any changes.
•Scroll to and select option “5) Test” on the Keypad Menu.
•Test sensors as described below.
•If you subscribe to the SimpliSafe alarm monitoring service, a test signal will appear in
your online account dashboard.
•Press
off
to exit test mode. Any errors will be announced by the Base Station.
A. Put your system in test mode
Congratulations! Setup is complete and you can
start using your SimpliSafe system now. Feel free
to read on for more information about your system.
Please remember to test your system regularly.
4. Test Your System
`
When in test mode, the Base Station will announce each
sensor as you test it, to confirm it is working properly:
Motion Sensors: Press the “test” button underneath the
Motion Sensor. For an accurate test, leave the room for
the sensor you are testing then wait 15 seconds. Re-enter
the room and the Base Station will say “Motion Sensor.”
Glassbreak Sensors: Press “test” on the bottom of the
sensor then clap your hands loudly near your windows.
The light on the sensor will flash and you will hear
“Glassbreak Sensor” from the Base Station.
Entry Sensors: Open and close protected doors and windows. The Base Station will
say “Entry Sensor” to confirm that it has received the signal.
Panic Buttons: Hold the panic button down for 1 second. The Base Station will say
“Panic Button” when it receives the signal.
Smoke Detectors: Hold the “test” button on the front of the sensor for 4 seconds. The
sensor will beep 3 times, then the Base Station will say “Smoke Detector.”
CO Detectors: Hold the “test” button on the front of the sensor for 4 seconds. The
sensor will beep 4 times, then the Base Station will say “Carbon Monoxide Detector.”
Water and Freeze Sensors: Press the “test” button on the top of each sensor. The Base
Station will anounce the sensor type to confirm that it has received the signal
B. Test your sensors
Press button underneath
motion sensor