Installation Guide

Simply Seamless Carpet Tile
Installation Guidelines and Recommendations
Tools Needed
Tape Measure, Chalk Line, Razor Blade Knife, Straight Edge
Prior to Installation
The floor should be smooth, flat, clean, dry, and free of any debris that
could affect adhesive. Remove anything that is not well adhered to the
floor. It is recommended to remove or seal old adhesives. Damp
mopping and vacuuming is recommended to ensure that floor is clean.
Fill all cracks and depressions that might impact the finished floor with
appropriate floor filler.
Floor temperature should be between 65 and 95 degrees Fahrenheit.
Store carpet tiles at room temperature for 24 hours prior to installation.
Installation
Measure the area to determine the best layout. It is preferable to have
larger cuts at perimeter walls. Often walls are not straight and the cut
size may change from one end of the room to the other. Take into
account doorways or other partitions when determining the best starting
point.
After determining your starting point snap chalk lines to use as a guide.
Layout chalk lines that bisect at the starting point and are at right
angles.
Installation should begin at this point and you may choose to lay the
tiles either in a straight grid or use a horizontal ashlar, or brick, pattern.
Once you are ready simply remove the liner from the back of the tile
and align the tile with the two chalk lines. Check the arrows on the
back of the tile and take care that all tiles are laid in the same direction.
As you lay each tile brush back the face fiber to keep it from being
trapped between the tiles. Butt the tiles snugly but do not compress the
tiles.
When you get to the perimeter cut measure the size needed and mark
the tile on the back with a felt tip or ball point pen. Prior to cutting
check the arrow to be certain that the fill tile will run the same direction
as the other tile in the room. Cut tile from the back and position the cut
edge at the wall.
When you have completed the installation, vacuum the carpet and stand
back to admire your new floor.
Make sure floor is
clean and ready for
carpet
Chalk Line Layout
Starting Tile
Standard Installation
Horizontal Ashlar*
(Brick) Installation
*Optional Layout