User Guide

12- ENG
6. Attach high pressure hose (C) to gun (D). Tightense cure ly.
E
D
CD
FIG. 3
FIG. 4
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered underwarranty.
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon aspossible.
OPERATION
PRESSURE WASHER TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure,etc.
GPM: Gallons per Minute. The unit of measure for the flow rate ofwater.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is
not pulled. This feature allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between cleaningactions.
WARNING: Do not allow the unit to run for more than two minutes without
the gun trigger being pulled. This could cause overheating and damage to
the pump. When the temperature inside the pump rises too high, the thermal
relief valve will open and release a spray of water from the pump to lower the
internal temperature. The valve will thenclose.
Thermal Relief Valve (P, Fig. 5): When the temperature inside the
P
FIG. 5
pump rises too high, this valve will open and release a gush of
water in an effort to lower the temperature inside the pump. The
valve will thenclose.
Detergent Injection System: Mixes cleaners or cleaning solvents
with the water to improve cleaningeffectiveness.
Water Supply: All pressure washers must have a source of water. The minimum
requirements for a water supply are 20 PSI and 5 Gallons Per Minute. If your water
source is a well, the garden hose length can only be 30ft. (9m)max.
WARNING: To reduce the possibility of contamination always protect
against backflow when connected to a potable watersystem.
PRESSURE WASHER OPERATING FEATURES
PRESSURE ADJUSTMENTS
The pressure setting is preset at the factory to achieve op ti mum pres sure
and cleaning. If you need to lower the pres sure, it can be accomplished by
thesemethods.
Back away from the sur face to be cleaned. The further away you are, the less
the pressure will be on the surface to becleaned.