User Guide
9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray
wand into the end
of the spraygun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure incoupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold WaterOnly.
7
Release Air from
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30seconds.
8
Verify the
Engine Switch
is turned to the
ON Position
9
Verify the Choke
Pin is pulled out
to the CHOKE
position
The Choke Pin has been
preset by the factory to
be in the CHOKEPosition.
10
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start theengine.
11
Push the Choke
Pin in to the
RUN Position
Gradually move the
Choke Pin to the
RUN Position after
enginestarts.
WARNING: This Guide is not a substitute for reading the operator's manual. User
must read and understand operator's manual before using thisproduct.