MSDS
ETI AND ETIG
ADHESIVE
-
MATERIAL SAFETY DATA SHEET
PAGE
2
OF
6
V.
FIRE
-
FIGHT
ING MEASURE
S
Suitable
Extinguishing M
edia
:
Water fog,
carbon dioxide or dry chemical,
aq
ueous foam
.
Fire And Explosion Hazard:
Hazardous
decomposition products
may occur when material
s
polymerize at
t
emperatures above
500
o
F.
Do not allow run
-
off from fire fighting to enter drains or
water courses.
Fire Fighting Equipment
and
Wear full protective clothing and
self
-
contained breathing apparatus
for fire fighting.
Procedures:
Isolate fuel supply from fire. Clear
fire area of all non
-
emergency personnel. Use water
spray to cool fire
-
exposed surfaces and containers.
VI
.
ACCIDENTAL RELEASE MEASURES
Personal Precautions:
Use cautious judgment when cleaning up spill. Shut off leaks, if possible without
perso
nal risk. Wear suitable protective clothing, gloves and eye/face protection.
Evacuate personnel to safe areas.
Environmental Precautions:
Construct a dike to prevent spreading.
Keep out of sewers, storm drains, surface waters,
and soils.
Clean
-
up Methods:
Small spills
: Soak up with
absorbent material such as clay, sand or other
suitable non
-
reactive
material. Place in l
eak
-
proof
containers. Seal tightly
for
proper disposal.
Large spills
:
Approach suspected leak areas with caution. Cre
ate a d
ike
or trench to
contain material.
Soak up with
absorbent material such as clay, sand or other
suitable
non
-
reactive
material. Place in l
eak
-
proof
containers. Seal tightly
for
proper disposal.
Additional
Information:
Notify
authorities if
any exposures to the general public or environment occur or are
likely to occur. Dispose
in accordance with federa
l, state, and local regulations.
VII.
STORAGE AND HANDLING
Storage:
Keep away from: acids, oxidizers, heat, or flames. Ke
ep in cool, dry, well
-
ventilated area
in closed containers. Protect conta
iners from physical damage.
Handling:
To prevent
skin and eye
contact under the foreseeable conditions of use, wear
appropriate protective clothing and safety eyewear.
When handling, do not eat, drink, or
smoke. Wash thoroughly after handling. Avoid breathing fumes. Handle
in a well
-
ventilated work area.
VIII.
EXPOSURE
CONTROLS / PERSONAL PROTECTION
Protective Measure:
Wear appropriate personal protective equipmen
t.
Eye Protection:
Avoid
contact with eyes. Wear chemical splash goggles or safety glasses with side
shield.
Hand Protection:
Wear chemical
-
resistant gloves such as: Nitrile, neoprene, butyl.
Skin and Body Protection:
Wear chemical
-
resistant gloves an
d other clothing as required
to
minimize
contact.
Respirator Protection:
Not required for properly ventilated areas.
Exposure Limits:
IX
.
PHYSIC
AL
AND CHEMICAL
PROPERTIES
Appearance
Specific Gravity
ETI Resin
Yellow liquid
1.125@ 72°F
ETIG Resin
Yellow paste
1.151@ 72°F
Odor:
Sweet
Vapor Pressure:
Not Volatile
Boi
ling Point
:
N/E
Freezing Point:
N/E
Flash Point
:
250
o
F
(Open Cup)
Solubility In Water:
N/E
COMPONENT
ACGIH
(TLV)
OSHA
(PEL)
BisPhenolA/Epichlorohydrin (Epoxy Resin)
N/E N/E