SDS

CRACK-PAC
®
Injection Epoxy
SAFETY DATA SHEET
CRACK-PAC
®
Page 4 of 8
North America SDS
8. Exposure Controls / Personal Protection
Personal Protective Equipment
General Protection: Wear appropriate personal protective equipment.
Eye Protection: Wear chemical splash goggles or safety glasses with side shield.
Hand Protection: Wear chemical-resistant gloves such as: Nitrile, neoprene, butyl.
Skin and Body Protection: Wear long sleeve shirt/long pants and other clothing as required to minimize contact.
Respirator Protection: If engineering controls do not maintain airborne concentrations below recommended
exposure limits (where applicable) or to an acceptable level (in countries where exposure
limits have not been established), an approved respirator must be worn.
General Hygiene: Always observe good personal hygiene measures, such as washing after handling the
material and before eating, drinking, and/or smoking. Routinely wash work clothing and
protective equipment to remove contaminants.
Engineering Controls
When using indoors good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be
matched to conditions. Ready access to running water is required. Provide eyewash station.
Exposure Limits
After Cu
Additional Information
After Cure: After Cure: Product forms an innocuous solid. Processing after cure (grinding or cutting) may
produce dust containing compounds that present an inhalation hazard.
9. Physical and Chemical Properties
Property
Resin
Hardener
Physical State:
Liquid
Liquid
Color:
Blue
Clear
Odor:
Strong Acrid
Ammonia
pH:
No data
12
Flammability limit – lower %:
Flammability limit – upper %:
No data
No data
No data
No data
Vapor Pressure:
No data
No data
Vapor Density:
No data
No data
Solubility:
Insoluble in water
Slightly soluble in water
Freezing/Melting Point:
No data
No data
Boiling Point:
No data
No data
Flash Point:
>250 °F (121.1 °C) Open Cup
230 °F (110 °C) Closed Cup
Evaporation Rate:
No data
No data
Decomposition Temperature:
No data
No data
Specific Gravity:
No data
No data
VOC (after cure):
7 g/L
7 g/L
Kow:
No data
No data
Viscosity:
No data
No data
Corrosiveness:
Non-corrosive
Corrosive
10. Stability and Reactivity
Resin (blue side)
Reactivity: This product is stable and non-reactive under normal conditions.
Chemical Stability: Stable under normal storage conditions.
Condition to Avoid: High heat and open flame.
Substances to Avoid: Oxidizing agents, acids, organic bases, and amines.
Component
OSHA
(PEL)
ACGIH
(TLV)
NIOSH
Pocket Guide
Benzene-1,3-dimethane
amine (CAS 1477-55-0)
N/E
0.1 mg/m
3
(Ceiling)
0.1 mg/m
3
(Ceiling)
Diethylenetriamine
(CAS 111-40-0)
N/E
1 ppm (TWA)
4 mg/m
3
(REL, TWA)
1 ppm (REL, TWA)