SDS

ManualsBrandsSimpson Strong-Tie ManualsPaintEpoxy-Tie 22 oz. Cartridge

SET

Anchoring Adhesive

SAFETY DATA SHEET

SET

Page 1 of 10

1. Identification

Product Identification

Product Identifier: SET (SET22, SET56, SETPAC10, SETPAC-EZ, SET1.7KTA)

Recommended Use: High Strength Anchoring Adhesive – Epoxy Resin

Use Restrictions: None Known.

Company Identification

Company: Simpson Strong-Tie Company Inc.

Address: 5956 W. Las Positas Blvd.

Pleasanton, CA 94588

Phone: 1-800-999-5099

Website: www.strongtie.com

Emergency: 1-800-535-5053 (US/Canada)

1-352-323-3500 (International)

For most current SDS, please visit our website at www.strongtie.com/sds

2. Hazard Identification

General Information

SET Anchoring Adhesive is a two part system. The two parts of this product have been assessed according to GHS and are

classified below. The final hardened material is considered nonhazardous. Some hazards apply upon grinding or cutting

through hardened product.

Resin (white side) GHS Classification

Physical Hazards: Not Classified.

Health Hazards: Skin Corrosion/Irritation Category 2

Serious Eye Damage/Irritation Category 2A

Sensitization, Skin Category 1

Germ Cell Mutagenicity Category 2

Environmental Hazards: Chronic Aquatic Environmental Hazard Category 2

Signal Word: WARNING!

Hazard Statements: Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction.

Suspected of causing genetic defects. Toxic to aquatic life with long lasting effects.

Precautionary Statements:

Prevention: Obtain special instructions before use. Do not handle until all safety precautions have

been read and understood. Wear protective gloves/protective clothing/eye protection/face

protection. Contaminated work clothing should not be allowed out of the workplace.

Avoid breathing mist or vapor. Wash thoroughly after handling. Avoid release to the

environment.

Response: If exposed or concerned: Call a poison center/doctor. If on skin: Wash with plenty of

water. If skin irritation or rash occurs: Get medical advice/attention. Take off

contaminated clothing and wash before re-use. If in eyes: Rinse cautiously with water for

several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If

eye irritation persists: Get medical advice/attention. Collect Spillage.

Storage: Store locked up. Store in a well-ventilated place. Store between 45-90°F (7-32°C).

Disposal: Dispose of contents/container in accordance with local/regional/national/international

regulations.

Summary of content (20 pages)

PAGE 1
SET® Anchoring Adhesive SAFETY DATA SHEET 1. Identification Product Identification Product Identifier: Recommended Use: Use Restrictions: Company Identification Company: Address: SET (SET22, SET56, SETPAC10, SETPAC-EZ, SET1.7KTA) High Strength Anchoring Adhesive – Epoxy Resin None Known. Simpson Strong-Tie Company Inc. 5956 W. Las Positas Blvd. Pleasanton, CA 94588 Phone: 1-800-999-5099 Website: www.strongtie.
PAGE 2
SET® Anchoring Adhesive SAFETY DATA SHEET Hardener (black side) GHS Classification Physical Hazards: Health Hazards: Environmental Hazards: Signal Word: Hazard Statements: Precautionary Statements: Prevention: Response: Storage: Disposal: Not Classified.
PAGE 3
SET® Anchoring Adhesive SAFETY DATA SHEET Resin (white side) Chemical Name Bisphenol A/Epichlorohydrin Phenol, polymer with formaldehyde, glycidyl ether Butyl Glycidyl Ether Titanium Dioxide CAS Number 25068-38-6 28064-14-4 2426-08-6 13463-67-7 Weight % 40-60 40-60 1-10 1-10 CAS Number 1317-65-3 100-51-6 140-31-8 80-05-7 98-00-0 84852-15-3 112-24-3 103-83-3 98-54-4 14808-60-7 Weight % 30-50 10-20 5-10 5-10 1-5 1-5 1-5 1-5 <2 <1 Hardener (black side) Chemical Name Limestone Benzyl Alcohol 2-Piperazin-1-
PAGE 4
SET® Anchoring Adhesive SAFETY DATA SHEET 6. Accidental Release Measures Personal Precautions Keep unnecessary personnel away. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Wear appropriate personal protective equipment. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Avoid inhalation of vapors or mists. Ensure adequate ventilation.
PAGE 5
SET® Anchoring Adhesive SAFETY DATA SHEET OSHA (PEL) ACGIH (TLV) NIOSH Pocket Guide Benzyl Alcohol (CAS 100-51-6) N/E N/E 44.2 mg/m3 10 ppm Furfuryl alcohol * (CAS 98-00-0) N/E 15 ppm (STEL) 10 ppm (TWA) 40 mg/m3 10 ppm 270 mg/m3 50 ppm 3 ppm 30 mg/m3 (Ceiling) 5.6 ppm (Ceiling) 5 mg/m3(respirable) 15 mg/m3(total dust) 10 mg/m3 N/E Component *Skin Designation N-Butyl Glycidyl Ether (2426-08-6) Titanium Dioxide (13463-67-7) Additional Information After Cure: 9.
PAGE 6
SET® Anchoring Adhesive SAFETY DATA SHEET 11. Toxicological Information Likely Routes of Exposure Ingestion: Inhalation: Skin contact: Eye contact: Information on Toxicological Effects Acute toxicity: Ingestion may cause irritation to the gastrointestinal tract. This material is a viscous liquid to semi-solid which does not easily form vapors. Inhalation of processing dust may irritate the respiratory tract. Harmful in contact with skin. Causes severe skin burns. Causes skin irritation.
PAGE 7
SET® Anchoring Adhesive SAFETY DATA SHEET Component Species Test Result 2-Piperazin-1-ylethylamine (140-31-8) Aquatic, Fish, LC50 Fathead Minnow 1950-2460 mg/l, 96 hours Benzyl alcohol (CAS 100-51-6) Aquatic, Fish, LC50 Bluegill 10 mg/l, 96 hours Nonylphenol (CAS 84852-15-3) Aquatic, Crustacea, EC50 Clam 0.0379 mg/l, 48 hours Aquatic, Fish, LC50 Winter Flounder 0.017 mg/l, 96 hours Bisphenol A (CAS 80-05-7) Aquatic, Crustacea, EC50 Daphnia 9.2-11.4 mg/l, 48 hours Aquatic, Fish, LC50 Fathead Minnow 3.6-5.
PAGE 8
SET® Anchoring Adhesive SAFETY DATA SHEET Additional Information Special precautions for user Read safety instructions, SDS and emergency procedures before handling. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code This substance/mixture is not intended to be transported in bulk This information does not cover all specific regulatory or operational requirements of this product.
PAGE 9
SET® Anchoring Adhesive SAFETY DATA SHEET Massachusetts RTK Chemical Quartz (14808-60-7) Triethylenetetramine (CAS 112-24-3) Butyl glycidyl ether (CAS 2426-08-6) Titanium dioxide (CAS 1317-80-2) New Jersey Work and Community RTK Act Pennsylvania Worker and Community RTK Law Listed Listed Listed Listed Listed Listed Listed Listed Rhode Island RTK Canada This product has been classified according to the hazard criteria of the CPR and the SDS contains all of the information required by the CPR.
PAGE 10
SET® Anchoring Adhesive SAFETY DATA SHEET Additional Hardener (black side) Classifications NFPA Ratings HMIS Rating HEALTH HAZARD 3 FLAMMABILTY HAZARD 1 PHYSICAL HAZARD 0 PERSONAL PROTECTION B 1 3 0 Abbreviations ACGIH: CAS No.: CERCLA: CPR: DOT: EPA: GHS: HEPA: HMIS: IARC: IATA: IMDG: LPP: NIOSH: NFPA: NTP: OSHA: PEL: SARA: SDS: STEL: STOT: TLV: TSCA: TWA: U.S.
PAGE 11
SET® Anchoring Adhesive SAFETY DATA SHEET 1. Identification Product Identification Product Identifier: Recommended Use: Use Restrictions: Company Identification Company: Address: SET (SET22, SET56, SETPAC10, SETPAC-EZ, SET1.7KTA) High Strength Anchoring Adhesive – Epoxy Resin None Known. Simpson Strong-Tie Company Inc. 5956 W. Las Positas Blvd. Pleasanton, CA 94588 Phone: 1-800-999-5099 Website: www.strongtie.
PAGE 12
SET® Anchoring Adhesive SAFETY DATA SHEET Hardener (black side) GHS Classification Physical Hazards: Health Hazards: Environmental Hazards: Signal Word: Hazard Statements: Precautionary Statements: Prevention: Response: Storage: Disposal: Not Classified.
PAGE 13
SET® Anchoring Adhesive SAFETY DATA SHEET Resin (white side) Chemical Name Bisphenol A/Epichlorohydrin Phenol, polymer with formaldehyde, glycidyl ether Butyl Glycidyl Ether Titanium Dioxide CAS Number 25068-38-6 28064-14-4 2426-08-6 13463-67-7 Weight % 40-60 40-60 1-10 1-10 CAS Number 1317-65-3 100-51-6 140-31-8 80-05-7 98-00-0 84852-15-3 112-24-3 103-83-3 98-54-4 14808-60-7 Weight % 30-50 10-20 5-10 5-10 1-5 1-5 1-5 1-5 <2 <1 Hardener (black side) Chemical Name Limestone Benzyl Alcohol 2-Piperazin-1-
PAGE 14
SET® Anchoring Adhesive SAFETY DATA SHEET 6. Accidental Release Measures Personal Precautions Keep unnecessary personnel away. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Wear appropriate personal protective equipment. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Avoid inhalation of vapors or mists. Ensure adequate ventilation.
PAGE 15
SET® Anchoring Adhesive SAFETY DATA SHEET OSHA (PEL) ACGIH (TLV) NIOSH Pocket Guide Benzyl Alcohol (CAS 100-51-6) N/E N/E 44.2 mg/m3 10 ppm Furfuryl alcohol * (CAS 98-00-0) N/E 15 ppm (STEL) 10 ppm (TWA) 40 mg/m3 10 ppm 270 mg/m3 50 ppm 3 ppm 30 mg/m3 (Ceiling) 5.6 ppm (Ceiling) 5 mg/m3(respirable) 15 mg/m3(total dust) 10 mg/m3 N/E Component *Skin Designation N-Butyl Glycidyl Ether (2426-08-6) Titanium Dioxide (13463-67-7) Additional Information After Cure: 9.
PAGE 16
SET® Anchoring Adhesive SAFETY DATA SHEET 11. Toxicological Information Likely Routes of Exposure Ingestion: Inhalation: Skin contact: Eye contact: Information on Toxicological Effects Acute toxicity: Ingestion may cause irritation to the gastrointestinal tract. This material is a viscous liquid to semi-solid which does not easily form vapors. Inhalation of processing dust may irritate the respiratory tract. Harmful in contact with skin. Causes severe skin burns. Causes skin irritation.
PAGE 17
SET® Anchoring Adhesive SAFETY DATA SHEET Component Species Test Result 2-Piperazin-1-ylethylamine (140-31-8) Aquatic, Fish, LC50 Fathead Minnow 1950-2460 mg/l, 96 hours Benzyl alcohol (CAS 100-51-6) Aquatic, Fish, LC50 Bluegill 10 mg/l, 96 hours Nonylphenol (CAS 84852-15-3) Aquatic, Crustacea, EC50 Clam 0.0379 mg/l, 48 hours Aquatic, Fish, LC50 Winter Flounder 0.017 mg/l, 96 hours Bisphenol A (CAS 80-05-7) Aquatic, Crustacea, EC50 Daphnia 9.2-11.4 mg/l, 48 hours Aquatic, Fish, LC50 Fathead Minnow 3.6-5.
PAGE 18
SET® Anchoring Adhesive SAFETY DATA SHEET Additional Information Special precautions for user Read safety instructions, SDS and emergency procedures before handling. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code This substance/mixture is not intended to be transported in bulk This information does not cover all specific regulatory or operational requirements of this product.
PAGE 19
SET® Anchoring Adhesive SAFETY DATA SHEET Massachusetts RTK Chemical Quartz (14808-60-7) Triethylenetetramine (CAS 112-24-3) Butyl glycidyl ether (CAS 2426-08-6) Titanium dioxide (CAS 1317-80-2) New Jersey Work and Community RTK Act Pennsylvania Worker and Community RTK Law Listed Listed Listed Listed Listed Listed Listed Listed Rhode Island RTK Canada This product has been classified according to the hazard criteria of the CPR and the SDS contains all of the information required by the CPR.
PAGE 20
SET® Anchoring Adhesive SAFETY DATA SHEET Additional Hardener (black side) Classifications NFPA Ratings HMIS Rating HEALTH HAZARD 3 FLAMMABILTY HAZARD 1 PHYSICAL HAZARD 0 PERSONAL PROTECTION B 1 3 0 Abbreviations ACGIH: CAS No.: CERCLA: CPR: DOT: EPA: GHS: HEPA: HMIS: IARC: IATA: IMDG: LPP: NIOSH: NFPA: NTP: OSHA: PEL: SARA: SDS: STEL: STOT: TLV: TSCA: TWA: U.S.