Use and Care Manual

11 - ENG

G. Handle

. Frame

I. Pump Outlet

J. Pump Inlet

K. Quick Connect Nozzles

Dial-N-W

ash

Adjustable Pressure Regulator: Use the Dial-N-Wash to

increase and decrease the pressure. Refer to the Dial-N-Wash Adjustment

paragraph.

BASIC ELEMENTS OF AN ENGINE

Refer to the Engine Owner’s Manual for location and operation of engine controls.

hoke Control: Opens and closes carburetor choke valve.

tarter Grip: Pulling starter grip operates recoil starter to crank engine.

Engine Switch: Enables and disables ignition system.

ASSEMBLY INSTRUCTIONS (FIG. 2 – 4)

1. Locate and remove all loose parts from the carton.

Cut four cor

ners of the carton from top to bottom and lay the panels flat.

Place handle (G) onto frame (H),

depress the snap buttons, and slide

the handle assembly onto the frame

until snap buttons snap into place.

NOTICE: Risk of personal injury. Avoid

placing hands between handle and

frame when assembling to prevent

pinching.

Remove the color

ed quick-connect nozzles (K) from the plastic bag and insert

them into correct grommet on the nozzle holder. Nozzles are color coded to

match colored nozzles on label (Q).

5. Connect wand (E) to gun (D). Tighten securely.

6. Attach high pressure hose (C) to gun (D). Tighten se cure ly.

NOTE: The pump on this unit is maintenance free and requires no oil. If

there is a problem with the pump, contact our Customer Service Group on

www.simpsoncleaning.com as soon as possible.

NOTICE: The engine is shipped without oil. Before starting engine, add the oil

provided. Damage to the engine will occur if the engine is run without oil, this

damage will not be covered under warranty.