Pump Manual

7
STEPS TO STORE AND PROTECT YOUR PUMP
During long term or season storage of three months or longer, the residual fluid left in the pump can cause corrosion, sticking valves and mineral
deposits. For equipment stored where the temperatures drop below freezing the pump can be damaged from water freezing in the manifold.
Using Cat Pumps specially formulated Pump Protector (Part # 6108, 12 oz bottle) will help prevent any damage during storage.
1. Turn engine/motor to
Off position.
2. Disconnect all hoses. 3. Unscrew blue valve from
bottle and remove white
internal seal.
4. Thread blue valve back
onto bottle.
9. Electric Pressure Washers
Briefly turn pressure washer
on until pump protector
fluid is discharged from
pump outlet, then turn
unit Off.
10. Remove bottle from
garden hose fitting.
Store or dispose of bottle
properly.
5. Remove black protective
cap to expose male garden
hose thread and internal
check valve.
8. Gas Pressure Washers
Pull starter cord until pump
protector fluid is discharged
from pump outlet.
DO NOT START ENGINE.
6. Screw bottle into garden
hose fitting on inlet
of pump.
7. Squeeze bottle to inject
pump protector fluid
into pump.