Replacement Part List

15 - ENG

2. Check engine oil level. See Engine Owners Manual for correct procedure.

3. Connect the water hose to the water source. Turn the water source on to

remove all air from the hose. When a steady stream of water is present, turn

the water source off.

4. Verify the filter screen (M) is in

water inlet of pump.

NOTE: Cone side faces out.

5. Connect high pressure hose (C)

to pump outlet (I).

6. Connect water source (N) to

pump inlet (J).

NOTE: Water source must

provide a minimum of 5 gallons

per minute at 20 psi.

WARNING: To reduce the possibility of contamination always protect

against backflow when connected to a potable water system.

7. Choose the correct nozzle for the job to be performed. See How To Use spray

Wand instructions in this section. NOTE: If applying a chemical or cleaning

solution, see How To Apply Chemicals/Cleaning Solvents instructions in this

section.

8. Turn water source on.

NOTICE: Risk of property damage. Failure to do so could cause damage to the

pump.

9. Remove all air from the pump and high pressure hose by depressing trigger

until a steady stream of water is present.

10. Start engine. See Engine Owners Manual for correct procedure.

WARNING: Risk of unsafe operation. If engine does not start after two

pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly

until resistance is felt. Then pull cord rapidly to avoid kickback and prevent

hand or arm injury.

11. Depress trigger on gun to start water flow.

WARNING: Risk of unsafe operation. Stand on a stable surface and

grip gun/spray wand firmly with both hands. Expect the gun to kick when

triggered.

12. Release trigger to stop water flow.

WARNING: Risk of injury from spray. Always engage the

trigger lock (O) when gun is not in use. Failure to do so

could cause accidental spraying.

SHUTTING DOWN

1. After each use, if you have applied chemicals, place

detergent siphon hose into container of clean water and

draw clean water through chemical injection system to

rinse system thoroughly.

NOTICE: Risk of property damage. Failure to do so could cause damage to the

pump.

2. Turn engine off. See Engine Owner’s Manual.