Replacement Part List

9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
7
Release Air from
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
30 S
8
Verify the Engine
Switch is in the
ON Position
See label #8 on unit.
9
Move the Choke
to the CHOKE
Position
See label #9 on the engine.
10
Pull the Recoil Starter
Grip
Pull the recoil starter
grip to start the engine.
See label #10 on unit.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
11
Move the
Choke to the
RUN Position
Gradually move
the Choke to the
RUN Position after
engine starts.
See Label #11
on the engine.