Technical data

14 Daily Use
To pause press Start/Pause. The
indicator will start flashing.
-
Press the Start/Pause again. The
program will continue.
-
5.2 Interruption Of A Program
5.3 Changing A Program
It is possible to change only some
options after the program has
started.
Press the Start/Pause button.
The indicator will start flashing.
1.
Change the options.2.
Press Start/Pause again. The
program will continue.
3.
While a program or the delay start
is operating, the appliance door is
locked and the ‘Door Lock’ pilot
light come on.
5.4 Changing The Options
5.5 Opening The Door
First set the machine to PAUSE by
pressing the “Start/Pause” button.
Wait until the door lock indicator
goes off, then the door can be
opened.
Changing a running program is possible
only by resetting it.
Turn the program selector knob to
the position ‘ ’ to cancel the
program and to turn off the
appliance.
1.
Turn the program selector knob to
the new program position and set the
new option, then press ‘Start/Pause’
button again.
The appliance will not drain the
water.
2.
If required, pour fabric softener into
the compartment marked (the
amount used must not exceed the
“MAX” mark in the drawer).
-
Close the drawer gently.
-
ATTENTION!
If you turn the program selector dial to
another program when the machine is
working, the red Start/Pause pilot light
will flash 3 times to indicate a wrong
selection. The machine will not
perform the new selected program.
The appliance will automatically
adjust the selected program duration
according to the type and size of the
load.
-
Step 4 - Starting a program
To start a program, press the
Start/Pause ( ) button, the
corresponding pilot light will stop
flashing and a default program
duration will be displayed on the
screen.
After approx. 15 minutes from
the start of a program: