User manual

ADD THE DETERGENT

1. Measure the correct amount of powder or liquid detergent by

following the recommendations on the package.

2. Mix detergent in one litre of hot or warm water.

3. Add the pre-mixed detergent to the wash load.

Don’t do these things:

* Use too little detergent because you will get a poor wash.

* Use too much detergent as this will give you too many suds and

may cause overloading of the motor during the spin stage of the

wash cycle. To avoid excessive suds, reduce the amount of detergent

you use. It is best to use detergent labelled low sudsing. Good quality, front

load detergent will perform well in this machine.

* Use soap based products in your washing machine.

ADD FABRIC SOFTENER

1. Measure the correct amount of fabric softener by following the

recommendations on the package.

2. Mix softener with an equal amount of warm water but only mix

enough to fill to the line marked inside the cup. The softener cup

holds 75ml.

3. Pour the mixed softener into the cup in the top of the agitator.

Do not overfill the cup.

4. Do not spill fabric softener on the clothes as it may stain them.

IMPORTANT: If you are going to use fabric softener, you must select

the DEEP RINSE option, ie deselect the ECO RINSE option.

NOTE: You do not have to use fabric softener, your washing machine

will wash the clothes perfectly well without it.

ADDING BLEACH

Bleaching of clothes can help to remove stains, heavy soiling and

to kill bacteria.

Oxygen type - This is generally a powder type bleach.

Mix the required quantity with water and pour down the hole in the

top panel during the fill when there is some water in the wash bowl.

Refer to the instructions on the bleach container.

Chlorine type - This type of bleach should not be mixed with detergent.

Mix the bleach with water as per the instructions on the container.

Turn PROGRAM SELECTOR to a wash program position.

Press the START/PAUSE button to commence water fill.

Pour the bleach solution down the hole in the top panel during fill

when there is some water in the wash bowl.

Allow the machine to agitate for a few minutes, then let it stand for

the required time by pressing the START/PAUSE button.

Turn PROGRAM SELECTOR to Drain & Spin position and press the

START/PAUSE button to empty the wash bowl.

You can now wash the clothes load using detergent and your selected

wash program.

NOTE: Bleach should not be used on silk, wool, rayon or drip dry

clothes.