Owners manual
|
11
Installation | Broadband 3G/4G™ Radar Installation Guide
Connect interconnection cable to the scanner
The scanner interconnection cable connects the scanner to the RI10 interface box (or Lowrance
HDS via and ethernet adapter cable - 3G U.S only). The cable connects to the scanner using a
14 pin connector.
• Protect the connectors when pulling cable through the boat and avoid putting strain on
to the connectors
• The interconnection cable is 9 mm in diameter. A 14 mm hole will be required in order
for the RJ45 connector to pass through (Interface box end) or 24 mm for the scanner end
connector
• Run the interconnection cable between the scanner and the location of the radar inter-
face box
• Insert cable connector on to the male 14 pin plug on the scanner
• Take care to align the connector correctly to avoid bending the pins. Secure the locking
collar by rotating clockwise until it clicks
• Feed and secure the cable into the cable retention channel
Scanner Interconnection cable pin out
Scanner connector
Cable connector
Diameter = 23 mm
Pin-out Wire color RJ45
1 Black Tinned wire
2 Red Tinned wire
3 Yellow Tinned wire
4 Drain Tinned wire
5 N/A N/A
6 Blue RJ45 Pin 4
7 White / Blue RJ45 Pin 5
8 White / Brown RJ45 Pin 7
9 Brown RJ45 Pin 8
10 White / Green RJ45 Pin 3
11 N/A N/A
12 White / Orange RJ45 Pin 1
13 Green RJ45 Pin 6
14 Orange RJ45 Pin 2
RADAR_3G_4G_IG_988-10113-003_EN_P.indd 11 2/11/2011 6:08:40 p.m.