Operation Manual

Installation | 25
2.13 S35 NFU Lever installation
The unit is mounted to a bulkhead or panel by two screws
from the front. The cable is connected to the autopilot
computer according to Figure 2-19. Interchange the Port
and Stbd wires to the screw terminals if necessary to
make the direction of the lever movement coincide with
the direction of the rudder movement.
Autopilot Computer
S35
Steering
Lever
REMOTE
LAM
P
Y
ellow
Brn/Wht
Pnk/Gry
Green
STBD
PO
RT
GND
Figure 2-19 S35 connections
The unit is opened by removing the three screws on the
back cover. Inside are two sets of micro-switches, a
printed circuit board with a plug-in terminal and a jumper
strap.
2.14 Interfacing
With the autopilot system there are several possibilities
to connect to other equipment for data collection and
exchange:
1 Use SimNet
2 Use SimNet via AT10 Universal SimNet/NMEA
Converter
3 Connect to a NMEA2000 network via adapter
(drop) cable, part no. 24005729.
The different connecting diagrams on the following pages
illustrate the interface possibilities of the autopilots.