Installation manual

8 |
Installation and wiring | AC12N/AC42N Autopilot Computers
Remove the bottom cover to get access to the plug-in terminals.
Provide sufficient wire length so that the plug-in terminals can be
easily connected and disconnected.
Pull out each terminal before connecting the wires. Remove all
strands before putting back the terminal cover.
A Micro-C NMEA 2000
cable is supplied with the
autopilot computer. It has a
connector in one end, and
the other end is prepared
for screw terminals.
AC12N Board Terminals
AC42N Board Terminals
¼ Note: White wire may be yellow on other compatible SimNet cable
versions!