System information

74 | Setup at installation

- Set the trim tabs and stabilizers to have no effect

on the boat’s heading

- Steer the boat manually on a steady course

- If required, confirm the rudder ZERO position by

pressing the

softkey

Compass calibration

Before the compass calibration is started, make sure that

there is enough open water around the vessel to make a

full turn.

The calibration should be done in calm sea conditions and

with minimal wind to obtain good results. Use about 60-

90 seconds to make a full circle.

1. Highlight the Calibrate line in the dialog

2. Begin turning the boat to port or starboard

3. Press the MENU key to start the automatic compass

calibration

c. An information window will be

displayed when the calibration

procedure is running.

d. The digits below the bargraph

will read 0.0 when the turn

rate is correct. Too high or too