Operation Manual

12 |
Introduction | AP70/AP80 Installation Manual
Rear - connectors
2 31
No. Connector/Description
1 4 pin connector for 12/24 V DC local power, External alarm/Active unit OUT
2 Micro-C connector for CAN bus
3 Ethernet network port, used for sw update
Autopilot computers
The AP70/AP80 systems use a combination of 5 different enclosures and 4 boards to form a
flexible computer and interface system.
There are 7 standardized and 1 customized computers with built-in and optional boards as
shown below.
Refer “Computer boards” on page 74
SG05 PRO
The SG05 PRO Autopilot Computer provides autopilot control from AP70 and AP80 control
units to CAN bus/EVC steering systems.
The SG05 PRO receives sensor data (drive/rudder angle and boat speed) from the EVC, does
steering calculations and sends drive/rudder commands back to the EVC system which brings
drive/rudder to commanded angle.
AC70
SI80
AC85
SD80
AD80
AC80A
AC80S
SG05
PRO