Operation Manual

| 41
System conguration | AP70/AP80 Installation Manual
System conguration
General
When the autopilot installation is completed, the system must be configured and the
commissioning procedures performed. Failure in setting up the autopilot correctly may
prohibit the autopilot from functioning properly.
The settings dialog and submenus
The system configuration settings are logically grouped in the Settings dialog, and each
group is presented with an icon. This dialog is accessed by pressing the Settings icon available
in all mode specific menus, or by double clicking the MENU key.
Icon Description Refer
System settings. These settings have no affect
on autopilot performance
AP70/AP80 Operator
manual
Work profile settings
Active alarms, alarm history and alarm
settings
Units of measure used on display, in dialogs
and menus.
-
Network sources setup
“Network settings” on page
42
Installation setup.
The pilot must be in Standby mode to access
these settings
“Installation settings” on
page 46
Turning on for the rst time
Before attempting to turn on the autopilot and perform an Installation Set-up, the hardware
installation and electrical installation must be completed and performed in accordance with
the installation instructions
The first time the autopilot system is started and after a factory reset, you will be guided
through a set of initial settings. On additional control heads, acknowledge language selection
and cancel all other setup requests.
If the settings are not completed, you can configure the autopilot system manually as
described in the following sections.
4