Service manual

Status and error messages
Message Explanation
6 P2265E/F
LAN UDP port busy *
LAN 82586 init error Unable to initialize 82586 chip. Possible hardware fault.
Maximum depth alarm # Bottom of transceiver-# has been detected deeper than the
maximum depth alarm setting
Minimum depth alarm # Bottom of transceiver-# has been detected shallower than the
minimum depth alarm setting
Navigation telegram error Invalid navigation telegram received
Ping interval warning Ping interval time exceeded
Printer-1 not ready Printer-1 not connected, offline or not ready to print yet
Printer-2 not ready Printer-2 not connected, offline or not ready to print yet
Printer-3 not ready Printer-3 not connected, offline or not ready to print yet
Rem. annotation received Remote annotation has been received successfully
Remote command ignored Remote control received while remote control disabled
Remote parameter entered Remote parameter received, decoded and entered successfully
Remote request executed Remote request has been executed successfully
Serial Com. load warning Too much data is directed to serial port, data may soon be lost
Serial Com. overload Too much data is directed to serial port, data is lost
Serial line 1 error Serial port 1 failure
Serial line 1B error RD display serial port failure
Serial line 2 error Serial port 2 failure
Serial line 3 error Serial port 3 error
Serial line 4 error Serial port 4 error
Serial receive overload Unable to receive more data on serial port. Data is lost
Unknown error *
Unknown remote command Invalid remote command path/parameter received
Unknown transceiver type Transceiver hardware switch not recognized
Display processor error Display/graphic processor (80786) malfunction
Disk error 0
File not found
Replay end of file
Replay data not found
Replay bad data
File create error
File open error
File write error
File close error