Technical data

Instruction Manual
11
E03766 Issue 3.0
• The icon indicates that the selected channel is included
in Memory Scan.
• Press and hold until double beep sounds to scan all chan-
nels (display shows “SCAN”).
• Press and hold until triple beep sounds to inhibit/enable
selected channel from scan (display shows “INH” or “ENA”
respectively). The icon indicates the channel is inhibited.
D/W - Dual Watch & T/W – Tri-Watch (9)
• Press to select Dual Watch of selected channel and Ch16
(the display shows “D/W”).
• Press and hold until double beep sounds for Tri-Watch –
selected channel, personal channel, and channel 16 (the dis-
play shows “T/W”).
16 - Channel 16 / Personal Channel (10)
• Press to select channel 16.
• Press and hold until double beep to select personal channel
(display shows ).
• Press and hold for three beeps to set selected channel as
the personal channel.
- Backlight (11)
• Press to turn on and off. Use ▲/▼ to adjust the backlighting
level (five levels available). The bargraph indicates the back-
lighting level.
• The battery save function turns the backlighting off if no key
is pressed after 20 seconds. Press any key (except or ) to
turn the light on again.
2.2 Selecting secondary channel
sets
In countries where it is permitted, holding VOL down while
turning the radio on will enable the radio to operate on a
secondary set of channels (Fig 2.3).
Where the display will normally show “INT” (International
channel set) on the bottom line, this will show “USA” for USA
channels, “CAN” for Canadian channels, etc.
• Channel sets available will depend on which country the
radio is programmed for use in. This function will only be
available if permitted in the country of purchase (for details
refer to sections 3.1 and 3.5).
• The radio will revert to International channels if it is
switched off, then on again.
Keep VOL pressed
Fig 2.3 - Selecting alternative
channel sets