Operation Manual

Installation | Broadband 3G/4G™ Radar Installation Guide

Connect interconnection cable to the scanner

The scanner interconnection cable connects the scanner to the RI10 interface box (or Lowrance

HDS via and ethernet adapter cable - 3G U.S only). The cable connects to the scanner using a

14 pin connector.

• Protect the connectors when pulling cable through the boat and avoid putting strain on

to the connectors

• The interconnection cable is 9 mm in diameter. A 14 mm hole will be required in order

for the RJ45 connector to pass through (Interface box end) or 24 mm for the scanner end

connector

• Run the interconnection cable between the scanner and the location of the radar inter-

face box

• Insert cable connector on to the male 14 pin plug on the scanner

• Take care to align the connector correctly to avoid bending the pins. Secure the locking

collar by rotating clockwise until it clicks

• Feed and secure the cable into the cable retention channel

Scanner Interconnection cable pin out

Scanner connector

Cable connector

Diameter = 23 mm

Pin-out Wire color RJ45

1 Black Tinned wire

2 Red Tinned wire

3 Yellow Tinned wire

4 Drain Tinned wire

5 N/A N/A

6 Blue RJ45 Pin 4

7 White / Blue RJ45 Pin 5

8 White / Brown RJ45 Pin 7

9 Brown RJ45 Pin 8

10 White / Green RJ45 Pin 3

11 N/A N/A

12 White / Orange RJ45 Pin 1

13 Green RJ45 Pin 6

14 Orange RJ45 Pin 2

RADAR_3G_4G_IG_988-10113-003_EN_P.indd 11 2/11/2011 6:08:40 p.m.