Operation Manual
|
13
Installation | Broadband 3G/4G™ Radar Installation Guide
Shortening the cable
It is not recommended to shorten the cable, but if it is unavoidable, use the pin-out below to
re-terminate the cable with a new RJ45 plug.
RJ45 Connector pinout
P1P8
Pin Color
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8Brown
Required to complete
RJ45 Connector RJ45 Crimping tool
Mounting the radar interface box
• Install the radar interface box (where applicable) in a dry location away from spray, rain,
drips and condensation
• The radar interface box must be located where it can be easily connected to the ship’s
power source, the scanner interconnection cable, SimNet/NMEA2000 and the display or
display network
• Allow enough room for cables to form a drip loop
• Preferably mount the radar interface box on a vertical surface with cables exiting
downwards
• Insert connectors . See “Connect the interconnection cable to radar interface box” on page
12
• Secure to the surface using the four mounting points and supplied 8G x 5/8 pozi s/s fasters
RADAR_3G_4G_IG_988-10113-003_EN_P.indd 13 2/11/2011 6:08:45 p.m.