Operation Manual

16
|
Connect the Broadband radar to your display | Broadband 3G/4G™ Radar Installation Guide
B&G Zeus
Simrad NSO, NSE and NSS
(SimNet network)
+
_
NMEA2000 cables
SimNet cables
Ethernet cable
Ethernet cables if
using NEP-2
FUSE
FUSE
FUSE
7
4
6
5
8
7
9
12
10
3
2
Parts required for
Chart overlay / MARPA
SimNet Network
Brown RX-
White RX+
AT10HD
NMEA083 to SimNet
Converter Heading Only
Cut off 12 Pin
plug to expose bare wires
NMEA0183 10 Hz Heading
(e.g Gyro, Sat Compass)
Alternative: NMEA0183 heading
TX-
TX+
11
1
SimNet
Ethernet
B&G Zeus
SIMRAD NSO, NSE
or NSS MFD
1. B&G Zeus or Simrad NSO / NSE / NSS
2. Broadband 3G™ or 4G™ Radar
3. Interconnection cable: Ships with a 20 m (65 ft). Optional 10 m (33 ft) and 30 m (98 ft)
4. RI10 Radar interface box
5. Ethernet cable (1.8 m (6 ft)). The RI10 can be connected directly to the NETWORK port of the
display/processor box, or via a Network Expansion Port (7). For cable options see “Ethernet
cables” on page 28
6. Ethernet cables required to connect 3G™ / 4G™ via a NEP-2 (6)
7. NEP-2 Ethernet switch
The following Parts required for MARPA and / or chart overlay:
8. For B&G Zeus, Simrad NSE, NSO: SimNet cable. (Not supplied)
For SimRad NSS: SimNet to Micro-C cable (Not supplied) see “SimNet - NMEA2000 adapter
cables” on page 28
9. SimNet drop cable. Allows display to receive heading information for chart overlay
10. RC42 Heading Sensor (22090195)
11. AT10HD. For installations with a NMEA0183 heading sensor
12. SimNet Network
Zeus
SimNet
Ethernet
NSO
SimNet
Ethernet
NSE
SimNet
Ethernet
NSS
NMEA2000
Ethernet
RADAR_3G_4G_IG_988-10113-003_EN_P.indd 16 2/11/2011 6:09:01 p.m.