Operator`s manual

Pilot menu & navigation examples Chapter 6-17

routepoint.

GOTO

Pressing [GOTO] from chart display during navigation will activate

an INFO window with the following functions to choose from:

1. Advance (to next routepoint)

2. Restart to approaching point (in case you have drifted off course)

3. Turn NAV OFF

6.9.4 Track navigation

A track is created by a series of trackpoints connected by track lines.

Using a track for navigation is somewhat like navigating in a route

with many waypoints.

 To start Track navigation will require that at least one track is stored

in the memory. Tracks which are not yet completed can not be used

for navigation. Refer to section 9.5 Start / Stop track.

There are two ways to start Track navigation:

• From the chart:

Place cursor on the track at the point where you wish to start your

navigation from

GOTO

Call up the GOTO menu, and...

Select Track navigation mode

This will activate the pop-up window “Navigate in track” with the

selected trackpoint as first destination point. Check if any of the cur-

rent settings need to be changed.

ENT

Start navigation

• From the chart, without first placing cursor on a track:

GOTO

Call up the GOTO menu, and...

Select Track navigation mode