Operator`s manual

Engine monitoring Chapter 7-1

7. Engine menu

ENG

Engine status - see section 7.1

Fuel and transmission - see section 7.2

Battery status - see section 7.3

2nd Engine status - see section 7.4

2nd Fuel and transmission - see section 7.4

2nd Battery status - see section 7.4

This graphical engine monitoring system is available for engines

outputting data via NMEA2000

or an appropriate interface device

supporting NMEA2000

. Depending on the engine system and

interface, some data may not be transmitted on the databus. If not

readily available, please contact the engine manufacturer or your

local Simrad dealer.

The CX NavStation is capable of receiving and presenting vari-

ous engine data in either full screen or split screen with two or all

three data displays on same screen. The menu points 4, 5 and 6 are

a second set of displays, which only will be visible if the system

detected more than two engines on board.

For dual engines, the system provides ‘dual bar analog instruments’

to give a precise overview of the rpm synchronization and to make

direct comparison of data between the two engines.

The displays can be accessed one at a time via the Engine menu or

all three displays at once by pressing:

Call up the menu bar, and...

4,8

press [4] and [8] to call up a custom made screen presenting the

position display and all three engine displays

This custom made screen is from the pilot menu. Refer to section

6.8 Pilot custom screens, where you also can read about how to

exchange the engine monitoring displays with other displays more

relevant in case you do not have engines on board which are capable

of outputting the required data.