Operator`s manual

Chapter 7-2 Engine monitoring

The engine monitoring system provides analog graphical gauges and

digital (numerical readings) data for up to four engines - see display

examples further on in this chapter.

General settings

SimNet will auto detect the engines at start-up and will automati-

cally set up the parameters in default mode. Before using the engine

monitor system, you may want to edit the setup to customize the

read-out. The top line identifies the engine/battery, the default is

ENGINE 1 to 4 or BATTERY 1 to 4. Insert the correct name for the

engine/battery in the Interface setup:

Call up the menu bar, and...

8,2

load the Interface setup

PLOT

Use the [PLOT] key to go to the Engine tab

Go to the name you wish to change,

- refer to section 2.6 Naming of routes, points etc.

ENT

Confirm entry and exit

 To change the measuring units, refer to ‘Setup for units’ in section

10.5.