Operator`s manual

Engine monitoring Chapter 7-3

7.1 Engine status

Call up the menu bar, and...

5,1

load the Engine status display

Forward Reverse (N = Neutral)

The numbers at the bottom represents Engine 1 to the left and

Engine 2 to the right in each column.

The Engine status display will provide data from 1 or 2 engines.

If there are more than 2 engines on board (and connected to the

system), a second Engine status display is available by pressing:

[MENU], [5], [4].

The default ranges in the Engine status display can be viewed and

changed as described below, except for Tilt, which is read-only

information of the exact tilt of the outboard engine in percentage, or

of the Stern drive. No range or limitation can be entered.

To change the default settings:

ADJ

Load Engine status setup

- see display example next page.

Left engine source - use +/- to toggle between connected engines.

Right engine source - use +/- to toggle between connected engines.

Engine RPM range, default is 5000 RPM. Selectable in steps from

2500 to 12500 by means of the +/- keys.