Operator`s manual

Waypoint / route menu Chapter 9-23

Receive WPs and routes

Press [7] to enable reception of waypoints and routes from the plan-

ning program

The transmission of waypoints and routes can now be activated from

the PC program. The info window below will inform you of the

progress of the reception of data by keeping an eye on the counter.

When the counter stops, means that all the data from the PC plan-

ner has been collected. However, some PC programs may continue

to transmit the same data over and over again and will have to be

stopped by pressing [ENT].

Receive WPs and routes

Reception in progress

37 WPs received

5 routes received

Stop and save

ENT

Stop and save

- will stop collecting data (if not already finished) and start saving

the collected data.

 Waypoints/routes transmitted to the CX34/44/54 are added to the

WP/route list. However, if two waypoint/route names are identical,

the latest transferred one will not be saved, even though position(s)

may be different. Routepoints will not be included in the WP list.

Saving the collected data can take anywhere from less than a second

and up to a few minutes, depending on the amount of data. If it takes

too long and you need the CX34/44/54 in a hurry, then press the

[MENU] key to Stop saving any more data - what has been saved

until this point will stay in the memory, the rest will be lost.

Stop saving

Under normal circumstances we assume the saving procedure is

allowed to finish and will indicate “Saving completed” in the info

window. You are now ready to:

Exit function and return to normal NMEA communication