Operator`s manual

Chapter 10-10 Setup menu
Miscellaneous menu). Toggle with +/-.
Start position - can be inserted if the exact start position is known.
Speed and course filter level - there is a filter of 10 steps available
(0= fast response, 9= stable readout).
Display speed as - SOG Speed Over Ground or STW Speed
Through Water. Toggle with +/-.
 To receive STW information will require connection of external
instrument via the SimNet system or the NMEA port.
Course and bearing as - readings of course and bearing can be
made in either MAGNETIC or TRUE. Toggle with +/-.
COG vector length - (default to 6 minutes) - indicates own course
and speed. The length of the COG vector reflects a distance run
during the specified number of minutes at the immediate speed.
Grounding alarm - the function will require a valid position, COG,
SOG and a C-MAP C-card inserted in the drawer below the keypad.
When an alarm is activated, an info-window will state the cause of
the alarm. Reset with [CLR].
Depth alarm - will be activated if the depth at the COG vector end
point is less than the value in the Pilot/Position setup and the alarm
is set to ON.
Object alarm - will be activted if set to ON and an object is detected
beneath the ship i.e. rocks, wrecks, etc.
Time - can be set to UTC or local. Toggle with +/-
Correct actual time and date by means of the numeric keys.
10.5 Speed alarm, units & language
MENU
Call up the menu bar, and...
8,1
load Speed alarm, units & language display
- see display example next page.