Operator`s manual

◄
GOTO
Compass Wind Eng
PLOT
►
Waypoint location input:
Source (none available):
NONE
Target Lat/Lon input:
Source (none available):
NONE
NMEA0183 output:
Waypoint location: WPL OFF
Routes: RNN OFF
Routes: RTE OFF
MENU
Exit Accept
ENT
∆
∆
Waypoint
◄
GOTO
Wind Waypoint Ala
PLOT
►
Engine 1: PORT
Teleflex PIN ,Sn:06952E-0
Engine 2: STARBORD
Teleflex PIN-1 ,Sn:060000-1
Battery 1: Battery 1
Teleflex PIN ,Sn:06952E-0
Battery 2: Battery 2
Teleflex PIN-1 ,Sn:060000-1
Engine/battery demo mode: OFF
MENU
Exit Accept
ENT
∆
∆
Engine
Chapter 10-20 Setup menu
PLOT
Go to Waypoint interface - step back with [GOTO]
Source - will indicate how many units are connected and available.
NMEA0183 output - see also section 10.6.1 Description of sentences.
PLOT
Go to Engine interface - step back with [GOTO]
PIN - Propulsion system (Engine interface).
To run a demo of the engine/battery monitoring system, use the
cursor to go to OFF and use the +/- key to toggle to ON. When ready
to connect the real system, be sure to turn off the demo mode again.
NMEA2000
®
output - see section 10.6.2 Description of sentences.