Operator`s manual

◄
GOTO
e SimNet diagnostic
PLOT
►
Example:
CX44/54
Alarm:
Output (pin 1,2): ON
Alarm stand-by level: LOW
Pos-status:
Output (pin 4,6): ON
Pos-status stand-by level: HIGH
Log:
Output (pin 5,6): ON
MOB-input:
(pin 3,6)
Long press (5 sec.): EXTERNAL MOB
Short press: OFF
MENU
Exit Accept
ENT
∆
∆
Alarm
◄
GOTO
ne SimNet diagnostic
PLOT
►
Example:
CX34
Alarm:
Output (REMOTE pin 2,5): ON
Alarm stand-by level: LOW
MOB-input:
(REMOTE pin 1,5)
Long press (5 sec.): EXTERNAL MOB
Short press: OFF
MENU
Exit Accept
ENT
∆
∆
Alarm
Setup menu Chapter 10-21
PLOT
Go to Alarm interface - step back with [GOTO]
Stand-by level can either be: LOW = 0 volt or HIGH = 5 volt.
MOB-input
• Press the external switch for more than 5 seconds to activate the
MOB function (fixed setting), and press the [ENT] key to start MOB
navigation.
• Short press on the external switch (less than 5 seconds) will shift