Operator`s manual

Fundamentals & initial start-up Chapter 2-9
New window: Automatic input source setup listing Data type, Group
and Source of connected units.
ENT
Press [ENT] to continue
PAGE
Press [PAGE] to scroll through a quick guide which informs of the
use of the keys and where you can enter owner’s setup, etc.
- the quick guide is also accessible via [MENU], [8], [5].
ENT
Press [ENT] when ready to assume normal operation
- go to [MENU], [8], [2] if you wish to make adjustments to the
interface setup.
) Heading is only available if a compass was detected at start-up.
PWR
Press [PWR] again to adjust the lighting in the screen and select day
or night display etc., move around in display by means of the cursor
key and change settings with +/- keys, and...
ENT
Confirm with [ENT]
Your present position will automatically be updated within a few min-
utes. When ready, the ship symbol on the chart will flash, the position
coordinates will stop flashing, and the *** will be replaced by actual
course and speed figures - see section 6.3 Position display.
Do not start radar transmission before the antenna is warmed up, refer
to section 3.2.3 Start transmission.
Select display language:
MENU
Call up the menu bar, and...
8,1
press [8], [1] to call up the language display
Press up on the cursor to go to the bottom line in the display
+/-
Select language
ENT
Confirm entry