Instruction manual

INSTALLATION
20221511 / C 39
5 Remove strips and foam rubber from the chock absorbers,
together with all strips used for securing moving parts
during transportation.
Note! The foam rubber should be kept for re-use if the Master compass
has to be sent to factory for service!
5.3 Cabling
Note! No cables are included when the gyro system is delivered from
factory.
The wiring diagram on page 70 onwards includes cable
specification for all cables that is to be used.
Caution If the optional Power Supply unit is included in the system,
jumper settings have to be modified as described in page 37.
Connect power and signal cables according to the wiring
diagram on page 70 onwards.
To avoid that vibration should cause the cables to loose
connection, the cables could be fastened to the fixing device by
using wire straps as illustrated on the figure.