Instruction manual

Simrad GC80/GC85 Compact Gyro Compass
44 20221511 / C
5 Position the Sensitive element on the Horizontal ring by
putting the assembly jigs into the holes as indicated on the
figure below. Observe the labelling and the diameter on
the jigs. Fasten two screws in the other two holes.
6 Replace the assembly jigs with the two remaining screws.
Locate the ground wire on one of the screws as shown on
the figure.
7 Loosen the screw on the plug holder on the Sensitive
element, and lift the holder 2-3 mm upwards.
8 Connect the plug to the connectors on the Sensitive
element’s pcb according to the labelling on the pcb and on
the wires. Make sure that the pin guides on the plug are
properly entered, and that the wires not are twisted.
9 Firmly tighten the screw on the holder.
ASSEMBLY JIG
WITH 1 CIRCLE
ASSEMBLY JIG
WITH 2 CIRCLES